Floor. Saturday , December 30th , 2017 - 21:10:25 PM
Without an accurate floor plan, it is also going to be haphazard to track how the air currents flow through a space, especially a large space. And yet it is so easy to see it all at a glance with the floor plan in front of us. In fact, we can even forewarn and advise a person regarding a house not yet built, if we have a floor plan to refer to. Another critical reason for having an accurate floor plan is in the circumstance where a home has been remodeled or added on to. In some cases, a house with an addition might be considered more than one house, technically, when we evaluate the addition on its own terms. If an addition constitutes more than half the square footage of the original foot print, then this may justify calculating the entire house as new, with the more current energy taking over the whole space, based on when the addition was done.
Sometimes only small adjustments need to be made, a mere few feet, to move a desk from a negative zone to a positive zone, but we can’t know that without an accurate floor plan. Another piece of practical advice I routinely give clients are the yearly zones to be wary of in terms of remodeling or accidents. For example, in the year 2012, the direction of southeast will be very accident-prone. If I have a client who wants to remodel their kitchen in that location and that year, we might consider postponing it or doing some specific counter-measures to diffuse the volatility of that area. But if we aren’t working with an accurate floor plan, then we could misinterpret where a directional zone is within a house. All of these theories apply to commercial spaces as well.
Once the floor is prepared and dried, you can start laying your ceramic tile flooring. It is best to lay the tile in pre-separated sections. Divide the floor into four sections. You can use grout as a line separator. Then, for each section, use a notched trowel to spread the mortar. Hold the trowel at a 45 degree angle so that it creates notches in the spread. This enables better holding when you set in the tile. Do not spread too much mortar at once. If the mortar dries before you can set the tile, you’ll have the additional problem of removing it. When you set the tile, only a light pressure is required. Depending on the thickness of your tile, you’ll have to press it into the mortar a short distance. Make sure that each tile is even with the next. Mortar will come up over the sides of the tile, but this can easily be wiped away. Avoid resting hands or arms on the tile you’ve set. It’s going to take a couple of hours before the mortar is completely dry. Grout the ceramic tile flooring, and wipe off any grout that gets on the tile.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does Newmanagerialism claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.